Common methods for detecting the quality of LED unit boards
Posted on

An important part of the LED electronic display is the LED unit board. If there is a problem with the unit board, it will directly affect the overall quality of the LED display! Therefore, how to distinguish the quality of the LED unit board is a concern of LED display merchants. The following summarizes some common methods for testing LED unit boards.
Material
LED unit board sheet
Some LED unit board manufacturers use cheap flame-retardant paper boards or single-sided fiber boards as PCB circuit boards for LED lights in order to compete at low prices. Because all glass fiber PCB boards are expensive. At first, no difference can be seen. Generally, within one year, it will be broken due to moisture, UV damage, oxidation and other reasons, resulting in the entire LED unit board being scrapped. High-quality LED unit boards must use double-sided all-glass fiber PCB boards. Although the cost is high, the quality is guaranteed.
2. IC devices
Observe whether the brand of the IC device used is consistent. What type of IC is used, and how many ICs are used, these are enough to affect the quality of the LED unit board. Some LED display manufacturers, in order to save costs, will deliberately reduce the number of ICs or mix other brands of ICs when producing unit boards.
3. Lamp beads and chips:
The naked eye cannot tell the quality of the lamp beads. Can only rely on a long test, which is the aging test that experts say. The general LED display manufacturer's approach is: power on before leaving the factory, and check whether the LED display can operate normally, it will not go through a long aging test. Because there are time costs and labor costs.
Welding quality
Check whether there are any missing or misplaced components on the chip, and whether there is a short circuit on the component pin burrs. Check whether the solder joints of the straight inserts are smooth and round, and whether the board surface is clean and tidy, and there is no missing welding. Check the insertion flatness of the luminous dot matrix and the consistency of the ink color.
Power-on test
Power-on test (refer to the steps of "Performance Test Report"):
â‘  Test the consistency of the luminous dot matrix when power on;
â‘¡ Power on test whether the line drive tube CEM4953 is effectively protected;
â‘¢ Power on to test signal transmission capability.
The above is a common method for detecting the quality of LED unit boards. I hope it will be helpful for LED display merchants. In addition, quality is king, and rejecting cheap and shoddy LED displays is also what manufacturers need to do to avoid damage to the unit board and affect normal work and subsequent unnecessary maintenance.

Aluminum profile cutting machine is major and essential equipment for manufacturing aluminum windows and doors. Cutting is the beginning of making aluminum windows, and one of most important manufacturing procedures in the whole window manufacturing process. The cutting accuracy (such as accuracy error of cutting length, accuracy error of cutting angle) will affect the corner crimping accuracy and corner crimping strength of aluminum windows, and then affect the size accuracy and angle accuracy of finished aluminum windows. STONE window machinery guarantees the cutting quality of the aluminum profile cutting machine through use of high quality hard-alloy saw blades, high accuracy liner bearing motional pairs and headstock, and other high quality machine components, and through our strict quality control system. Aluminum profile cutting machines mainly includes double-head cutting saw, single-head cutting saw, corner connector cutting saw, and so on.

Aluminum Cutting Machine

double head cutting saw, double mitre saw, double miter saw, aluminum profile cutting saw

Jinan Stone Machine Co., Ltd. , https://www.jnstonema.com