When it comes to controlling the amount of water on the sprinkler, this may be a concern for many drivers, because if it is to ensure that the sprinkler has a good state of operation, it will be able to implement greening and environmental protection. In the program, for a long period of time, the vehicle needs a lot of water, so how should the sprinkler control the water?

Some people who buy a sprinkler for the first time will always have an idea that they will think that the greater the number of sprinklers on the sprinkler is, the better. If the sprinkler is sprinkling water, the distance from the sprinkled water to the road surface will be shorter and shorter. In this case, the tanker of the sprinkler vehicle will be filled with water numerous times, increasing the number of times the water is added. However, the sprinkler is This process of going back and forth will also increase fuel consumption, making it impossible to achieve good economic results.

However, the number of sprinklers sprinkled water is not a specified parameter, and the actual situation is based on the conditions of the sprinkled ground has been determined by the weather at that time. If the road surface is relatively dry at that time, then the amount of watering should be increased for a long time. If the road is in a relatively humid environment when the weather is fine, the driver should reduce the amount of water sprayed. If there are some gravel and dirt roads, it is necessary to wait for the sanitation workers to clean the road before spraying.

However sprinkler watering amount can not be too large, excessive watering, it is likely to cause some low-lying sections of water, some water will flow into the water pipes along the road, which would virtually caused the economic and water resources The waste. In areas where there is a lot of mud and sand, it is easy to form muddy conditions when the water is sprayed too much. This can cause secondary pollution of the road surface. In more serious cases, it may even lead to sewers. Blocked situation. After waiting for the road to dry, a relatively large area of ​​pollution will be formed, which will inconvenience the sanitation workers' cleaning work. (Text / Sun Ni)

High Head Slurry Pump

MH slurry pump is horizontal ,centrifugal and single stage slurry pump. The MH high head slurry pump is specifically designed to combat the need to run conventional design slurry pumps at excessive speeds to generate high heads and high efficiency often required in many modern slurry pumping applications used as the filter press feeding pump, SAG Mill Discharge Slurry Pump and Wet Crusher Slurry Pump etc.Single pump unit rather than series pumping can be adopted, at greatly reduced capital cost, while still offering optimum wear life and efficiency.

Pump Features

-High chrome alloy liners provide superior abrasion resistance & erosion resistance and maximum wear life

-Large diameter, high efficiency impellers designed to meet high head requirement, maximum wear life and low operating cost

-High head & high pressure

-Discharge branch can be positioned at intervals of 45 degrees

-The pump can be installed in multi-stage high pressure operation

-Easy to maintain

Application Range:

Discharge Size:1" to 6"
3 Capacity:16 to 1125 m /h
Head:12 to 95 m

Mineral Processing Pump,Booster Slurry Pumps,Wear Resistant Slurry Pump,Abrasion Resistan Slurry Pump

SHIJIAZHUANG MUYUAN INDUSTRY & TRADE CO., LTD. , https://www.cnmuyuan.com