Productivity is based on feed rate. Maintaining a constant feed, the energy-saving continuous mixer can increase the rotor speed to obtain greater shear force, or a color master batch continuous mixer, or close the discharge door slightly to increase the discharge temperature. The internal mixer operates under normal pressure to form an independent mixing environment, which is completely unaffected by the molding requirements. The high quality cable material continuous mixer can mix materials with high shear rate and temperature, and can also mix materials with low shear rate and temperature sensitivity. Granulate directly after mixing. As for the research of continuous mixer equipment, on the one hand, it will continue to focus on powdering and pelletizing technology; on the other hand, the continuous mixer of high-quality cable materials is considered to be developed for continuous use of existing large materials or high viscosity materials Mixing equipment or partial continuous mixing equipment, the configuration advantages of continuous mixers will open up new mixing fields. Extrusion Line,Kneader Line,Kneader Extrusion,Kneader Extrusion Line Nanjing Juli Chemical Machinery Co., Ltd. , https://www.jlextruder.com
How to check the moisture in the generator oil
Diesel generator oil has a protective effect on the unit. If the quality of the oil is not high, it will affect the life of the diesel generator set. Choosing a good oil can provide a good maintenance effect on the generator set, but Sometimes there may be moisture in the oil due to misuse. How to check the moisture in the oil?
First, you can heat the oil to 110 to 120 degrees Celsius by placing it in a test tube. If there is a "beep" sound in the oil, indicate that there is water in the oil. If there is water in the oil, you can heat the oil to 110 by indirect heating. At 120 degrees Celsius, when the air bubbles in the oil disappear, it cools to normal temperature and the water is removed.
If the oil is lightly emulsified, it can be handled by collecting the same grade of emulsified motor oil, taking phenol (stone carbonate) with a weight of 1% to 3% by weight of the oil as a deemulsifier, stopping the stirring and heating. At 50 to 80 degrees Celsius, settle for 4 hours or longer. After the oil and moisture layers, remove the lower layer of water before use.
If the thickened oil is emulsified, it can be treated by air drying: the emulsified thickened oil is placed in a container with a clean serpentine heating tube, and the saturated steam is used to stop heating through the serpentine tube to raise the temperature of the oil. At 110 to 120 degrees Celsius, while introducing clean and tight air into the container, stop the agitation and evaporate the water until the milky white color of the oil disappears, returning to a transparent color, and then cooling to normal temperature.